Worktop fabrication in Colliers Wood

Yes. Colliers Wood is on the patch, and the postcodes we work here are SW19, CR4. It is worked on our south west London run, along with the rest of Merton. Where the bay sits some distance from the core, the carry across the car park is the longest leg of the day and gets boarded and lit. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The room is genuinely square and the units are plumb, so the visit is more about the building than about the kitchen. We work to the internal depth of the car and the diagonal you can actually stand a piece up on with the doors closed, then nest to that, which routinely turns a two-piece kitchen into a three-piece one with an extra join over a gable. Settled on the drawing, cut once. Developer kitchens here are built to a tight 600mm module with the sink already cut into a fixed position, so measure the existing cutouts before quoting a straight swap.

The new blocks have loading bays and a goods lift but both need booking with the concierge and there is a hard time limit on the bay. The older terraces sit on streets that back onto the river and industrial units, so vans get boxed in by delivery traffic on the A24. The lift has to be booked and blanketed before anything moves, and that booking needs to cover the old tops coming out as well as the new stone going in. The maximum piece length is fixed at drawing stage and every join is placed over a cabinet gable from there. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Housings and integrated appliances are set out for a 38mm laminate top, so dropping to 20mm or 30mm stone changes the clearances and needs checking before anything is cut. So the nesting is planned around it rather than around a standard kitchen. Nested for the job in front of us. Upgrading a builder-finish kitchen is mostly a swap, so the cost sits in the material choice rather than in the shape of the room. Pieces are dry-assembled and checked on the bench before anything is loaded. Same slab run, or it is not a match.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Pieces are dry-assembled on the bench before dispatch so the corners are known to close before they leave the workshop. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Boxing is rarely the same depth at worktop height as it is at floor level, so measuring it low down is the usual reason a top will not sit back. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. Radiused, polished, and clear of the joins. Sink, tap and hob need to be with us before machining, along with confirmation of whether the island is getting a breakfast overhang, since anything past roughly 300mm unsupported needs steel let into the carcasses and that has to be built in, not added later. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. Changing an appliance after the nest is set means recutting the piece, not adjusting it. The approved drawing is the instruction.