Worktop fabrication in South Wimbledon

Yes. South Wimbledon is on the patch, and the postcodes we work here are SW19. It is worked on our south west London run, along with the rest of Merton. Unrestricted kerbside is straightforward as long as the space in front of the property is actually clear when the van arrives. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A two-up two-down has a kitchen that was never designed to be one, so the run is short, the ceiling is low and every millimetre of depth gets argued over. The other constraint is the hall: a piece has to come through the front door, round the newel at the foot of the stairs and through a doorway into the back kitchen, so we size the pieces to the tightest turn on that route before we nest anything, which sometimes means splitting a run that would otherwise have gone in whole. Settled on the drawing, cut once. Old walls out here bow badly over a 3m run, so scribe generously and expect to take 10 to 15mm off the back edge rather than trusting the plaster line.

Front doors open more or less straight onto the pavement with no front garden to stage on, and Merton High Street plus the tram line limit where a van can sit. Hallways are around 900mm wide with a dogleg at the stairs, so the slab is turned on edge before the first corner. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop splashbacks & upstands and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Proven on the bench before dispatch. Landlord work is scheduled around void periods, so the whole thing is a fixed window and the template date matters as much as the fitting date. Pieces are dry-assembled and checked on the bench before anything is loaded. Nested for the job in front of us.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. Dry-assembled before it leaves.