Kitchen worktops in South Wimbledon

Yes. Small two-storey terraces where the kitchen stays in the original rear outrigger, a single 2.4m to 3m run with the boiler still on the wall and no room for an island. Landlord refits and first-time-buyer updates dominate, so it is usually swapping a tired laminate top for a slab and adding upstands rather than moving anything. A skip, a delivery lorry or a run of scaffolding takes the frontage the van needed, so the street is worth a look the day before rather than on the morning. The fitting slot is set around it, which is why we ask about it when the date is booked and not before we leave the yard. Camera enforcement does not take an explanation.

Victorian bylaw terrace, Edwardian terrace, Postwar council block and Above-shop flat. Many have had the ground floor chimney breast removed to gain three hundred millimetres, and the gained strip is newer blockwork standing proud of the old plaster. Lath-and-plaster on the party wall and the chimney breast returns almost never runs true, so a 100mm upstand bedded on silicone is the honest answer here, it rides the bow and hides the junction the worktop can never close on its own. A reveal in a thick wall changes where the panel stops.

Front doors open more or less straight onto the pavement with no front garden to stage on, and Merton High Street plus the tram line limit where a van can sit. Hallways are around 900mm wide with a dogleg at the stairs, so the slab is turned on edge before the first corner. An inward-opening door swinging back against the wall leaves less clear opening than the frame measures, and a storm porch in front of it is tighter again. Splashback panels are lighter than a worktop and far more awkward, because a tall thin piece has to be carried on edge and cannot be tilted to clear a turn. They come in last so nothing is carried past them.

Worktop replacement, worktop splashbacks & upstands and worktop installation, in that order. Damage in a let flat is settled as a deposit deduction, so a surface that can be repaired in place is worth more than one that has to be replaced whole. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Wipe-down beats sealed grout on a turnaround. Old walls out here bow badly over a 3m run, so scribe generously and expect to take 10 to 15mm off the back edge rather than trusting the plaster line.

Handles on opposing runs meet in the middle of the aisle, so a deep edge profile specified on both sides takes width out of the standing space twice over. Old laminate has often been holding a run square for years, and taking it off shows what the units were really doing. Level the units first, measure the shape second. Where two pieces meet over a fall in the floor the join has to be flush to the hand as well as true to the level, because the eye reads the join and forgives the room. The old top has been hiding it, so the first honest look at it happens when the laminate comes off. Nothing about it is a discovery on fitting day. Material is from £110 per square metre supply only, and the templating, the fabrication and the fitting are each quoted on their own line.

Whoever manages the block controls the lift booking, the bin store and the visitor parking, and none of that sits in the gift of the household whose kitchen it is. Full-height panels need the wall made good first, which is another trade and another timescale. What repeats across flats is recorded once and repeated. If we know the building when you book, the lift, the stair turn and any freeholder notice are worked into the day rather than found on it.

A long top on units that were shimmed once and never checked is the commonest version of this, and it is cheap to fix beforehand. Levelling belongs in the carcasses, on their own legs and packers. Floors settle, and once base units are packed and levelled properly the stone sits true while everything else in the room admits it is not. This is the commonest reason a replacement turns out to need more than a straight swap. The laminate was scribed thin. Stone cannot be.

No maintenance visit is built into the job. Soap, water, and on the porous stones a seal. Sealing is the one maintenance job that genuinely differs by material, and it is worth knowing which you are buying before the slab is chosen. Day to day all three want soap and water; abrasive creams and scouring pads are what dull a polished surface. The staircase rises over the back room in a good number of these, so a sloping bulkhead sits over one end of the run and a piece cannot be stood on edge beneath it. Where a client wants a full-height piece behind the hob, it usually sits in the old chimney recess, and that recess is rarely square top to bottom or side to side, so it has to be templated as a trapezium rather than a rectangle. Blown plaster comes off before stone goes on.

Our own installers do the carry, so there is nobody in the middle to argue with about it. Floors and units are protected before anything comes through the door. The workmanship guarantee runs 5 years on every kitchen we fit. A step up off the pavement means the piece is lifted to the threshold before it is carried anywhere, and that first lift is the one that wants four hands. It is usually the full-height panels rather than the tops that will not make the turn, and that only shows up when they arrive. Suction lifters take a panel where hands cannot get a grip.

A Belfast or butler sink has to be installed and at its final height before the template, because the stone is cut to sit on it. A piece with a bowl and a hob cut into it is the fragile one, and it is handled accordingly. Older houses put the boiler or the meter on one of the two walls, and whatever is boxed in around it sets the point where that run has to stop. Going from a 38mm laminate to 20mm or 30mm stone drops the surface, which shows against tiles, a window board and any freestanding appliance. The units stay, the surface changes.