Worktop fabrication in Merton Park

Yes. Merton Park is on the patch, and the postcodes we work here are SW19. It is worked on our south west London run, along with the rest of Merton. A free-parking street with cars both sides can still leave the van forty metres away, and that distance is carry, not driving. Pieces are loaded in reverse fitting order so the first thing off the van is the first thing that goes down. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Original joinery is deep and stands proud of the plaster, so the run is plotted to the units rather than to the wall behind them. Access is off a drive and through wide doors, so for once the piece size is not the constraint - the joins that go in are the ones we choose for layout and veining, not the ones the building forces. Settled on the drawing, cut once. Rooms here are rarely square, the original walls run out by 20mm or more corner to corner, so template the full room rather than assuming a 90 degree return at the dresser end.

Conservation area rules make skips and long-term van standing awkward, and the estate is characterised by clipped hedges and narrow gated front paths that a two-man carry cannot get a wide slab through squarely. The tram line splits the area, so the approach has to be planned from the right side of the crossing. The barrier, the entry code and the estate rules decide when a van can get near the door, and none of that is negotiable on the day. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop templating and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Pieces are dry-assembled and checked on the bench before anything is loaded. Same slab run, or it is not a match. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. So the nesting is planned around it rather than around a standard kitchen. Proven on the bench before dispatch.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. The drawing decides it, not the fitter. The range or Aga, the sink and the tap all need to be confirmed by model before nesting, because their clearances and hole positions set where the island can be cut. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. Changing an appliance after the nest is set means recutting the piece, not adjusting it. The approved drawing is the instruction.