Splashbacks and upstands in Ravensbury

Yes. Ravensbury is on the patch, and the postcodes we work here are CR4, SM4. It is worked on our south west London run, along with the rest of Merton. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. Upstands travel in a crate and can wait on the van, which gives some flexibility a full-height panel does not. Handling is where these pieces get damaged. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A maisonette puts the kitchen on one of two levels, so an internal staircase may be part of the route as well as the communal one. The rear kitchen wall in ex-council flats and maisonettes is commonly dense in-situ concrete or blockwork with a thin skim, which means mechanical fixings are hard work and the splashback is held on adhesive rather than screwed. The wall makes that decision, not the brochure. Maisonette kitchens usually back onto a shared party wall with a soil stack boxed in, and that boxing eats 150mm of the run that the plan does not show.

The Wandle and its parkland cut the area into pockets, so the drivable route to a front door is often not the obvious one on a map. Newer blocks have proper lobbies and lifts; the older maisonettes have external stair access only. A car that takes 2.4m on the diagonal will not take a three-metre worktop however it is stood, and there is no trimming it on the landing. Splashback panels are lighter than a worktop and far more awkward, because a tall thin piece has to be carried on edge and cannot be tilted to clear a turn. Joint positions follow from that.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Same batch, same run, same day. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. Ordered later from a different batch, the match is not reliable exactly where the pieces meet. Sockets final before template.

An island is a single visible piece with four finished edges and no wall to hide against, so it is the piece the whole kitchen is judged on. Long runs almost never take a single panel, so the joint positions want agreeing before anything is templated. Corners get their own pieces. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Boxing is rarely the same depth at worktop height as it is at floor level, so measuring it low down is the usual reason a top will not sit back. A tall panel that fits at the worktop will stand off the wall at the top unless the wall is dubbed out or the panel is scribed. Scribed, dubbed out, or set proud. Pick one. Any surface trunking or conduit has to be rerouted or accepted and boxed before templating, because the stone cannot be scribed around a live conduit on site. Where a landlord or housing provider is involved there is a specification to meet and a process to follow, and both are settled before a date is offered. Splashbacks are cut from the same slab run as the tops, so they have to be decided before fabrication, not after. Decided before fabrication, not after.