Kitchen worktops in Cranford

Yes. Extended semis with rear kitchen-diners, robust rather than showy specifications, long 3m to 4m runs against the back wall and splashback carried right up to the underside of the wall units. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. Panels come off the van in one trip where possible, since a tall piece handled repeatedly is a piece asking to be chipped. Handling is where these pieces get damaged.

Interwar semi, 1930s terrace, postwar infill and hotel-strip fringe development. The chimney breast in the corner has usually been left in place, so the run gains a return and two scribed ends. What catches people out is the junction between the old floor and the extension floor, which is rarely at the same level, so a run carrying across it needs the units packed before stone goes on. Units kept, surface changed, one day.

Straight off the A4 Bath Road, though the hotel strip and the M4 spur gridlock at airport shift changes. Drives are common on the residential streets. Even an easy kerbside carry wants the pavement clear at the tail lift, because a three-metre piece on edge has a swing radius nobody expects until it is swinging. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. It sets what the day actually looks like.

Worktop replacement, worktop installation and worktop splashbacks & upstands, in that order. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Same batch, same run, same day. Houses directly under the flight path have secondary glazing and unusually deep reveals, so stone window sill returns get asked for far more often here than elsewhere.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. A low sill over the sink run is what decides between an upstand and stone dying into a window board, and there is often less clearance than an upstand is tall. Rushing that is what leaves a gap you look at every morning for fifteen years. Eased in, never forced. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. A 100mm upstand is the low-maintenance answer, and full-height stone is the one that has to be committed to early. Decided before fabrication, not after. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.