Worktop replacement in Cranford

Yes. Cranford is on the patch, and the postcodes we work here are TW5, TW4. It is worked on our west London run, along with the rest of Hounslow. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. Old tops out and new stone in, both through the same gap. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The chimney breast in the corner has usually been left in place, so the run gains a return and two scribed ends. The junction between the old floor and the extension floor is where a run crossing it needs packing before stone goes on. Units kept, surface changed, one day. Houses directly under the flight path have secondary glazing and unusually deep reveals, so stone window sill returns get asked for far more often here than elsewhere.

Straight off the A4 Bath Road, though the hotel strip and the M4 spur gridlock at airport shift changes. Drives are common on the residential streets. The van gets close to the door and the stone comes off the tail lift onto a trolley, which is about the shortest carry we ever get. With no room to turn, the old top gets cut up in the kitchen instead, which is dusty work and needs the room emptied first. That is agreed before a plumber is booked.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop splashbacks & upstands. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Old tops out in the morning, new stone down and sealed the same afternoon. A day, not a project. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. The carcasses have to be sound, because stone is several times the weight of what is coming off. A day, not a project.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. Going from a 38mm laminate to 20mm or 30mm stone drops the surface, which shows against tiles, a window board and any freestanding appliance. Height change is checked before we cut. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A low sill over the sink run is what decides between an upstand and stone dying into a window board, and there is often less clearance than an upstand is tall. The old top has been hiding it, so the first honest look at it happens when the laminate comes off. The laminate has been covering it up. Unlock the side gate and clear the alley of bins, bikes and pots, and arrange a plumber for the sink and an electrician if the hob is hard-wired. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. If the carcasses are tired the honest answer is that stone will find that out, and it is better said before than after. Units kept, surface changed.