Worktop fabrication in Crayford

Yes. Crayford is on the patch, and the postcodes we work here are DA1. It is worked on our south east London run, along with the rest of Bexley. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The goods lift is generous and the flat entrance often is not, so the tightest point on the route is inside the flat rather than in the building. The kitchen is open plan and the island is often long enough to need a join, and it sits in the middle of the room where every edge is visible, so the join goes over a gable and usually under the hob line where the eye does not follow it. Every join over a gable, clear of every cut-out. The old works terraces have very low ceilings in the rear addition, check head height over the run before specifying tall upstands or a splashback.

The town is split by the main road and the river, with a steep hill up from the high street and terraced streets parked nose-to-tail; the riverside blocks have their own gated parking. Where the parking court sits behind the block the carry crosses open ground and gets boarded, because loaded trolleys and block paving do not agree. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. The drawing carries that decision through to the saw.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. So the nesting is planned around it rather than around a standard kitchen. Proven on the bench before dispatch. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Nested for the job in front of us.

A peninsula is an island with one end tied to a run, which means the join between them has to be planned rather than allowed to happen. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Window boards and cills stand proud of the plaster, so the back edge of the top has to be plotted to where the units actually sit rather than to the wall. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The island layout, including whether the ends are mitred down to the floor, needs settling before cutting, since mitred ends are cut in sequence with the top and dry-assembled as one unit. Consent for the work sits with the freeholder or the managing body, and getting it in writing first avoids a crew arriving to a locked door. Sink and hob are dry-fitted on the bench before dispatch, whoever supplied them. Dry-assembled before it leaves.