Splashbacks and upstands in East Barnet

Yes. East Barnet is on the patch, and the postcodes we work here are EN4. It is worked on our north London run, along with the rest of Barnet. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. Splashbacks are normally the last thing off, so a short parking window is exactly when they get rushed. Handling is where these pieces get damaged. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The kitchen is usually a rear room extended into the garden, with the original external wall now standing inside the run. These kitchens are nearly always retiled at least twice, and stripping the old tiles takes the bottom course of plaster with it because the original laminate top ran underneath the tiles rather than up to them. Decided before fabrication starts. New extensions here are often templated too early, before the floor screed has been laid, and the resulting unit height change is the commonest cause of a remake.

Wide residential roads with dropped kerbs and drives, decent side gates, and the valley of the brook meaning some roads dip steeply; the village centre itself has short-stay parking only. Rear access usually lets us fit longer pieces whole, so the join count ends up decided by the slab rather than by the building. It is usually the full-height panels rather than the tops that will not make the turn, and that only shows up when they arrive. It decides panel size before anything is cut.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop installation, worktop templating and worktop design & quotation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Ordered later from a different batch, the match is not reliable exactly where the pieces meet. Sockets final before template. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Siliconed to the worktop, never grouted.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. Upstands follow the run exactly, so every internal and external corner is a separate mitred or butted piece. Joint placement is a decision, not an accident. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Window boards and cills stand proud of the plaster, so the back edge of the top has to be plotted to where the units actually sit rather than to the wall. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. Scribed, dubbed out, or set proud. Pick one. The old tiling must be off and the wall made good and dry before templating, not on fitting day. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. Splashbacks are cut from the same slab run as the tops, so they have to be decided before fabrication, not after. Decided before fabrication, not after.