Splashbacks and upstands in New Barnet

Yes. New Barnet is on the patch, and the postcodes we work here are EN5, EN4. It is worked on our north London run, along with the rest of Barnet. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. Panels come off the van in one trip where possible, since a tall piece handled repeatedly is a piece asking to be chipped. One trip is always better than three. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Edwardian terraces are wider and taller than the Victorian houses next to them, so the kitchen usually takes a full-width rear room rather than a narrow outrigger. Where a client wants a full-height piece behind the hob, it usually sits in the old chimney recess, and that recess is rarely square top to bottom or side to side, so it has to be templated as a trapezium rather than a rectangle. Decided before fabrication starts. Victorian terraces here often have a step down into the rear kitchen, so the unit run sits on a different floor level and the top has to be set out from the units, not the wall.

Terraced streets near the station are permit-controlled and tightly parked, while the new blocks have designated loading and lifts. East Barnet Road is busy with limited stopping through the day. Where the lift will not take the longest run we design a join in rather than gamble, because a piece that will not go up has to go back on the van. Splashback panels are lighter than a worktop and far more awkward, because a tall thin piece has to be carried on edge and cannot be tilted to clear a turn. It decides panel size before anything is cut.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Siliconed to the worktop, never grouted. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Sockets final before template.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. Upstands follow the run exactly, so every internal and external corner is a separate mitred or butted piece. Joint placement is a decision, not an accident. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Level has to hold across the whole room rather than along one wall, or a floor that falls end to end shows as a step where two pieces meet. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. An upstand rides what a panel exposes. The chimney breast recess must be replastered and fully dry, and the hob and extractor positions fixed, before anyone templates a full-height piece into it. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. Full-height panels need the wall made good first, which is another trade and another timescale. Decided before fabrication, not after.