Worktop installation in New Barnet

Yes. New Barnet is on the patch, and the postcodes we work here are EN5, EN4. It is worked on our north London run, along with the rest of Barnet. Enforcement zones rarely accept a trade van unloading stone as an exemption, so this gets sorted before the date is confirmed rather than argued about afterwards. A van that has to move mid-fit costs the best part of an hour and takes a man off the tools to do it. It is why the arrival time is what it is. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The rear extension is frequently original rather than added, which means it is solidly built and just as far out of square as the rest of the house. The day is planned backwards from the hall, and the scribing takes longer than the carry. Walked, measured, protected, then lifted. Victorian terraces here often have a step down into the rear kitchen, so the unit run sits on a different floor level and the top has to be set out from the units, not the wall.

Terraced streets near the station are permit-controlled and tightly parked, while the new blocks have designated loading and lifts. East Barnet Road is busy with limited stopping through the day. A car that takes 2.4m on the diagonal will not take a three-metre worktop however it is stood, and there is no trimming it on the landing. The fitting day is planned backwards from that point, before anything comes off the van. It gets checked before the first piece is lifted.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. One visit, with the sink and hob seated and sealed before we leave. Sealed before we leave. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. The fitting day is scheduled to suit that rather than to suit the diary. One visit, done properly.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. The join is the last thing finished. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Floors settle, and once base units are packed and levelled properly the stone sits true while everything else in the room admits it is not. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Eased in, never forced. Clear the full hall and stairs route of furniture, bikes, coats and stair-gates, and keep the front door propped and unobstructed for the carry. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. A half-day of access is not a fitting day, and it is better to say so at booking than to find out at eleven. Protection goes down first.