Splashbacks and upstands in East Wickham

Yes. East Wickham is on the patch, and the postcodes we work here are DA16. It is worked on our south east London run, along with the rest of Bexley. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. Splashbacks are normally the last thing off, so a short parking window is exactly when they get rushed. One trip is always better than three. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Many have been extended at the rear since being sold, so the kitchen is half original and half newer with a floor junction between the two. Dense concrete takes adhesive better than fixings, which actually suits a large bonded panel. The wall makes that decision, not the brochure. Postwar units here are often 500mm deep rather than 600mm, so check before ordering standard-width worktop.

Quiet residential grid with front gardens, drives on the private housing and parking courts on the estate sections; vehicle access is easy throughout. Where the parking court sits behind the block the carry crosses open ground and gets boarded, because loaded trolleys and block paving do not agree. Where the route is tight we break a long splashback at a natural vertical joint instead of forcing one panel through. Joint positions follow from that.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop fabrication and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. Ordered later from a different batch, the match is not reliable exactly where the pieces meet. Same batch, same run, same day. Landlord work is scheduled around void periods, so the whole thing is a fixed window and the template date matters as much as the fitting date. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Sockets final before template.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. Long runs almost never take a single panel, so the joint positions want agreeing before anything is templated. Corners get their own pieces. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Boxing is rarely the same depth at worktop height as it is at floor level, so measuring it low down is the usual reason a top will not sit back. A tall panel that fits at the worktop will stand off the wall at the top unless the wall is dubbed out or the panel is scribed. An upstand rides what a panel exposes. Any surface trunking or conduit has to be rerouted or accepted and boxed before templating, because the stone cannot be scribed around a live conduit on site. Managed stock usually comes with its own rules about working hours, waste, and who is allowed on site. Full-height panels need the wall made good first, which is another trade and another timescale. Decided before fabrication, not after.