Worktop design and quotation in Eden Park

Yes. Eden Park is on the patch, and the postcodes we work here are BR3. It is run from the New Malden side, covering South West London & Surrey. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. Where a bay suspension or a permit is needed, that is a real cost and it goes on the quote instead of appearing later. Nothing here is added after the fact. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Solid brick with a render coat is firm to work against and out of plumb, so the scribe at worktop height is different from the one at plinth level. These are typically two runs and a return, often into a rear extension, and the return piece is the awkward one — short, wide and rarely nesting well against the long pieces on the slab, so slab yield rather than total area is what pushes the material line up. Priced from the building, not from a rate card. Peninsulas here nearly always end at a set of garden doors, so the end panel and overhang have to clear the door swing, which is worth checking at template rather than on fit day.

Short front drives that take one car, so the van usually parks half on the road, and side gates that are just about wide enough if the bins are moved first. Garden routes carry their own hazards: a drain cover, a step up to a patio, wet decking, or a lawn that will not take a loaded trolley. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. It appears as its own line rather than buried in a rate. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop installation, worktop replacement and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Itemised, so it can be compared honestly. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Nothing payable until we template.

The return piece is the awkward one on a slab: short, full depth, and rarely nesting neatly against the long lengths, so yield rather than area is what moves the material figure. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. Shape first, area second. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A low sill over the sink run is what decides between an upstand and stone dying into a window board, and there is often less clearance than an upstand is tall. Send photographs of every corner of the room and it gets priced properly first time. Better on the quote than in a variation. Send the extension drawing or the unit layout with the actual appliance model numbers, since cut-out sizes come from the appliance, not the cabinet. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. Material is quoted as a supply range and the labour lines separately, because an installed rate per square metre is not a real number. Every line has a reason next to it.