Splashbacks and upstands in Elmers End

Yes. Elmers End is on the patch, and the postcodes we work here are BR3. It is worked on our south east London run, along with the rest of Bromley. Where the van can pull up level with the gate the pieces are handled the fewest times, which is what actually protects them. Splashbacks are normally the last thing off, so a short parking window is exactly when they get rushed. One trip is always better than three. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Low-rise blocks are three or four storeys with a single stair and no lift, so pieces go up on edge and the half-landing sets the maximum length. Dense concrete takes adhesive better than fixings, which actually suits a large bonded panel. The wall makes that decision, not the brochure. On the older council-built stock the wall behind the run is often uneven render over brick, so a 20mm upstand hides more than a tiled splashback will.

Estate roads with unrestricted parking are fine, but the tram line and level crossings make timing awkward and several rows have rear-access alleys too narrow to use. A side gate and a back door mean the stone never goes through the house at all, which keeps the dust and most of the risk outside. Splashback panels are lighter than a worktop and far more awkward, because a tall thin piece has to be carried on edge and cannot be tilted to clear a turn. It decides panel size before anything is cut.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Sockets final before template. Quartz suits let property well: no sealing, no annual maintenance, and nothing an incoming tenant has to be told to look after. Ordered later from a different batch, the match is not reliable exactly where the pieces meet. Siliconed to the worktop, never grouted.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. The joint to the worktop is siliconed, never grouted. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Anything that has to stay accessible, a stopcock, a gas meter, a riser panel, is marked on the template so the stone is cut around it instead of over it. A tall panel that fits at the worktop will stand off the wall at the top unless the wall is dubbed out or the panel is scribed. Make the wall good first, or accept the detail. Any surface trunking or conduit has to be rerouted or accepted and boxed before templating, because the stone cannot be scribed around a live conduit on site. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. A 100mm upstand is the low-maintenance answer, and full-height stone is the one that has to be committed to early. Same slab run as the tops.