Worktop templating in Elmers End

Yes. Elmers End is on the patch, and the postcodes we work here are BR3. It is worked on our south east London run, along with the rest of Bromley. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The kitchen is a small square room off a narrow entrance lobby, and the turn out of that lobby is the real limit on piece length. Concrete and dense block walls in ex-council stock cannot be chased back or packed out to suit, so the template takes the wall exactly as it is and the stone carries the scribe. Recorded as it is, not as it was drawn. On the older council-built stock the wall behind the run is often uneven render over brick, so a 20mm upstand hides more than a tiled splashback will.

Estate roads with unrestricted parking are fine, but the tram line and level crossings make timing awkward and several rows have rear-access alleys too narrow to use. Garden routes carry their own hazards: a drain cover, a step up to a patio, wet decking, or a lawn that will not take a loaded trolley. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. It goes on the drawing with the run dimensions.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop splashbacks & upstands and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Units fitted, fixed and level first.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A boxed soil stack or service riser in the corner of a run eats into the worktop depth and has to be scribed around rather than cut square. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Plotted, not estimated. Every base unit fixed to the wall, packed and levelled, and any dry-lining or patching completed - the template reads the wall face it is given, so that has to be the finished face. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. A template booked hopefully around another trade is the commonest cause of a wasted visit. Fitted, fixed and level, then we come.