Worktop replacement in Fairlop

Yes. Fairlop is on the patch, and the postcodes we work here are IG6. It is worked on our east London run, along with the rest of Redbridge. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. We stage the strip-out so the old tops leave in one trip rather than trickling out across the afternoon. Old tops out and new stone in, both through the same gap. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Many have been extended at the rear since being sold, so the kitchen is half original and half newer with a floor junction between the two. Ex-council flats and maisonettes are built in dense concrete and blockwork, so anything that has to be fixed back, such as brackets under a peninsula or support for an end panel, goes in with proper anchors and an SDS rather than plasterboard fixings. Units kept, surface changed, one day. The recurring issue here is water damage in the sink base from the old top, so we check the carcass is still sound before we sit stone on it.

Open modern layouts with driveways, turning space and no restrictions, so the van parks on the plot. Garages and side gates give a second route in if the hallway is tight. A side gate and a back door mean the stone never goes through the house at all, which keeps the dust and most of the risk outside. With no room to turn, the old top gets cut up in the kitchen instead, which is dusty work and needs the room emptied first. It sets what the day actually looks like.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop splashbacks & upstands. Landlord work is scheduled around void periods, so the whole thing is a fixed window and the template date matters as much as the fitting date. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project. Quartz suits let property well: no sealing, no annual maintenance, and nothing an incoming tenant has to be told to look after. Old tops out in the morning, new stone down and sealed the same afternoon. A day, not a project.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. Going from a 38mm laminate to 20mm or 30mm stone drops the surface, which shows against tiles, a window board and any freestanding appliance. The units stay, the surface changes. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Anything that has to stay accessible, a stopcock, a gas meter, a riser panel, is marked on the template so the stone is cut around it instead of over it. The old top has been hiding it, so the first honest look at it happens when the laminate comes off. It is the usual surprise, and it is a known one. Sort a parking bay or permit near the entrance, confirm the lift is in service and get us the door codes, and tell us about any asbestos survey on the flat before we start stripping out. Consent for the work sits with the freeholder or the managing body, and getting it in writing first avoids a crew arriving to a locked door. If the carcasses are tired the honest answer is that stone will find that out, and it is better said before than after. Plumber either side of us.