Worktop fabrication in Fairlop

Yes. Fairlop is on the patch, and the postcodes we work here are IG6. It is worked on our east London run, along with the rest of Redbridge. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. Pieces are loaded in reverse fitting order so the first thing off the van is the first thing that goes down. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

An ex-council house is solidly built to a standard plan, with the kitchen at the rear and a back door next to it. Walls in the system-built blocks are concrete or panel and can bow noticeably over the length of a run, so the template picks up the real line and we cut the back edge to follow it rather than trimming on site with a grinder. Settled on the drawing, cut once. The recurring issue here is water damage in the sink base from the old top, so we check the carcass is still sound before we sit stone on it.

Open modern layouts with driveways, turning space and no restrictions, so the van parks on the plot. Garages and side gates give a second route in if the hallway is tight. Rear access usually lets us fit longer pieces whole, so the join count ends up decided by the slab rather than by the building. So the nesting is worked to the measured route first and to the slab second. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Landlord work is scheduled around void periods, so the whole thing is a fixed window and the template date matters as much as the fitting date. Pieces are dry-assembled and checked on the bench before anything is loaded. Nested for the job in front of us. Quartz suits let property well: no sealing, no annual maintenance, and nothing an incoming tenant has to be told to look after. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match.

If the island is a few hundred millimetres longer than the usable length of a slab, a second slab gets bought to gain that overhang, and the whole slab is paid for rather than the part used. Pieces are dry-assembled on the bench before dispatch so the corners are known to close before they leave the workshop. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A boxed soil stack or service riser in the corner of a run eats into the worktop depth and has to be scribed around rather than cut square. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The stack boxing needs to be in its final form and the sink and hob on site before we machine, since a boxing that gets re-clad afterwards throws the notch out. Where a landlord or housing provider is involved there is a specification to meet and a process to follow, and both are settled before a date is offered. Sink and hob are dry-fitted on the bench before dispatch, whoever supplied them. Dry-assembled before it leaves.