Worktop design and quotation in Forest Hill

Yes. Forest Hill is on the patch, and the postcodes we work here are SE23. It is run from the New Malden side, covering South West London & Surrey. Unrestricted kerbside is straightforward as long as the space in front of the property is actually clear when the van arrives. Where a bay suspension or a permit is needed, that is a real cost and it goes on the quote instead of appearing later. It is one line among the others, and it is honest. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

These kitchens are big rooms with long perimeter runs and an island, so level has to hold across the whole floor rather than along one wall. Big islands are what drive the number. That is what the itemised lines are for. The gradient is the constraint — check the van can hold the hill outside the house before planning the offload.

Very steep roads on both sides of the valley, tight bends and limited parking near the station; a lot of houses sit above the road behind long flights of steps with the garden well below. A narrow entrance hall with a turn into the back of the house caps the longest piece we can physically get in, whatever the run itself measures. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. You see that figure before we template, not after. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop installation and worktop fabrication. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Material is the slab only, and it says so. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Itemised, so it can be compared honestly.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. Shape first, area second. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A chimney breast left in place splits a wall into two alcoves, and the two are rarely the same width and rarely parallel to each other. It is fabrication time rather than material, so it appears on the fabrication line and not in the square metre figure. Better on the quote than in a variation. Send the island size including the overhang and which side people sit at, the stool count, and confirm the edge profile you want and which edges are to receive it. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. Material is quoted as a supply range and the labour lines separately, because an installed rate per square metre is not a real number. Nothing payable until template.