Splashbacks and upstands in Forest Hill

Yes. Forest Hill is on the patch, and the postcodes we work here are SE23. It is worked on our south east London run, along with the rest of Lewisham. Where the van can pull up level with the gate the pieces are handled the fewest times, which is what actually protects them. Panels come off the van in one trip where possible, since a tall piece handled repeatedly is a piece asking to be chipped. Handling is where these pieces get damaged. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A large villa has wide doors, a generous hall and somewhere to park, so the joins that go in are chosen for layout rather than forced by the route. Behind a range cooker with gas burners, granite or sintered stone is the sensible pick; quartz has a resin binder and does not enjoy sustained radiant heat at close range, so keep it out of the immediate hob zone or specify a different material for that panel. Cut from the same slab run as the tops. The gradient is the constraint, check the van can hold the hill outside the house before planning the offload.

Very steep roads on both sides of the valley, tight bends and limited parking near the station; a lot of houses sit above the road behind long flights of steps with the garden well below. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. Where the route is tight we break a long splashback at a natural vertical joint instead of forcing one panel through. Joint positions follow from that.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop installation and worktop fabrication. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Sockets final before template. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Siliconed to the worktop, never grouted.

An island is a single visible piece with four finished edges and no wall to hide against, so it is the piece the whole kitchen is judged on. Upstands follow the run exactly, so every internal and external corner is a separate mitred or butted piece. Corners get their own pieces. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a breast interrupts a long wall the join can often go there, so it reads as a natural break rather than a line in the middle of a worktop. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. Make the wall good first, or accept the detail. The range and extractor must be sited and the window cill finished before the template, as both fix the vertical limits of the splashback. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. Splashbacks are cut from the same slab run as the tops, so they have to be decided before fabrication, not after. Decided before fabrication, not after.