Worktop fabrication in Fortune Green

Yes. Fortune Green is on the patch, and the postcodes we work here are NW6, NW2. It is worked on our central and north London run, along with the rest of Camden. Without a bay the van ends up on a single yellow with a crew member watching it, which takes a pair of hands off the carry. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

An infill house is built to modern standards on an old plot, so the room is square even though the site around it is not. We work to the internal depth of the car and the diagonal you can actually stand a piece up on with the doors closed, then nest to that, which routinely turns a two-piece kitchen into a three-piece one with an extra join over a gable. Every join over a gable, clear of every cut-out. Edwardian rear walls here are usually rendered and bowed, so expect to scribe the back edge and pack the units before setting anything down.

Quiet residential streets with permit parking and better van access than most of NW6, though the climb up from Fortune Green Road is a real factor on the carry. Front doors open into a porch and then a hall with a right turn at the stairs, which is the pinch point on almost every house. Door width, hall width and the diagonal at the turn are three separate measurements, and it is the diagonal that catches people out. The maximum piece length is fixed at drawing stage and every join is placed over a cabinet gable from there. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop installation and worktop replacement. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Upgrading a builder-finish kitchen is mostly a swap, so the cost sits in the material choice rather than in the shape of the room. Pieces are dry-assembled and checked on the bench before anything is loaded. Same slab run, or it is not a match. Handover-spec kitchens are square, plumb and predictable, which means the join count is honest and driven by run length rather than by the building. So the nesting is planned around it rather than around a standard kitchen. Nested for the job in front of us.

An L can be mitred at the corner for a continuous look or butt-jointed over the gable, and the two are different money and different risk. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. Internal corners are machined with a radius and polished, and kept well clear of any join or cut-out. Radiused, polished, and clear of the joins. Sink, tap and hob need to be with us before machining, along with confirmation of whether the island is getting a breakfast overhang, since anything past roughly 300mm unsupported needs steel let into the carcasses and that has to be built in, not added later. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. Sink and hob are dry-fitted on the bench before dispatch, whoever supplied them. Changes cost a piece, not a tweak.