Worktop fabrication in Cricklewood

Yes. Cricklewood is on the patch, and the postcodes we work here are NW2. It is worked on our north west London run, along with the rest of Brent. Where the frontage is a clearway the unload happens away from the door and the carry gets longer, which is a crew and time question rather than a stone one. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

External walls are thick and the run under the window sits in a deep reveal that has to be templated rather than assumed square. The lift, if there is one, is a small passenger car with a gate, and the alternative is a stone stair winding round the shaft with a tight turn at every half-landing - so pieces get cut deliberately shorter than the slab allows and the kitchen is designed with more joins than it strictly needs. Settled on the drawing, cut once. First-floor maisonette kitchens are the recurring headache: the piece has to go up a domestic staircase with a half turn, so plan the joint before quoting a single length.

The Broadway is an A road with loading restrictions and bus lanes, so vans park in side streets and the crew carries. Mansion blocks vary wildly, some with a small original lift too shallow for a full slab and a stone staircase as the only alternative. Stone goes up on edge, and it is the half-landing turn rather than the flight itself that sets the maximum piece. The maximum piece length is fixed at drawing stage and every join is placed over a cabinet gable from there. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Same slab run, or it is not a match. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. Pieces are dry-assembled and checked on the bench before anything is loaded. Proven on the bench before dispatch.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. Pieces are dry-assembled on the bench before dispatch so the corners are known to close before they leave the workshop. Every join sits over a gable. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Anything that has to stay accessible, a stopcock, a gas meter, a riser panel, is marked on the template so the stone is cut around it instead of over it. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. Radiused, polished, and clear of the joins. Access arrangements and the porter's permitted hours need confirming before we cut, because the agreed piece size is what the nesting is built around. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. Changing an appliance after the nest is set means recutting the piece, not adjusting it. Changes cost a piece, not a tweak.