Worktop fabrication in Mapesbury

Yes. Mapesbury is on the patch, and the postcodes we work here are NW2, NW6. It is worked on our north west London run, along with the rest of Brent. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. Pieces are loaded in reverse fitting order so the first thing off the van is the first thing that goes down. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

These houses usually sit in their own grounds with a long approach, so the carry from van to door is longer than anything inside the building. Access is off a drive and through wide doors, so for once the piece size is not the constraint - the joins that go in are the ones we choose for layout and veining, not the ones the building forces. The bench proves it before the van moves. High-spec joinery means the fitter is working to the cabinetmaker's tolerances, so the template has to be booked after the carcasses are fixed and levelled, not while they are still loose.

Long front gardens and steps up to the door on most of the villas, and Article 4 and conservation controls mean owners rarely have off-street parking, so the carry from the kerb is longer here than in surrounding streets. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. It is settled on the bench, not on site.

It is one of the three we do most here, behind worktop design & quotation. Same template visit, same workshop, same installers either way. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Pieces are dry-assembled and checked on the bench before anything is loaded. Proven on the bench before dispatch. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. So the nesting is planned around it rather than around a standard kitchen. Nested for the job in front of us.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The range or Aga, the sink and the tap all need to be confirmed by model before nesting, because their clearances and hole positions set where the island can be cut. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. Sink and hob are dry-fitted on the bench before dispatch, whoever supplied them. Dry-assembled before it leaves.