Worktop templating in Mapesbury

Yes. Mapesbury is on the patch, and the postcodes we work here are NW2, NW6. It is worked on our north west London run, along with the rest of Brent. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Handmade brick and lime plaster move visibly along a run, and a straight-cut back edge shows it immediately. The island is templated for its overhang, its support and the position of the hob or sink within it, with sockets and any pop-up left where they will genuinely be. Recorded as it is, not as it was drawn. High-spec joinery means the fitter is working to the cabinetmaker's tolerances, so the template has to be booked after the carcasses are fixed and levelled, not while they are still loose.

Long front gardens and steps up to the door on most of the villas, and Article 4 and conservation controls mean owners rarely have off-street parking, so the carry from the kerb is longer here than in surrounding streets. Door width, hall width and the diagonal at the turn are three separate measurements, and it is the diagonal that catches people out. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. That is part of what the visit is for.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop fabrication and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Two to three hours on site, with the sink, tap and hob physically present. Units fitted, fixed and level first. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. That is why the visit takes two or three hours. All runs and the island carcass fixed down and levelled to one datum, with the sink, tap and hob on site - an island cannot be templated while it is still loose or sitting on packers. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. A template booked hopefully around another trade is the commonest cause of a wasted visit. Fitted, fixed and level, then we come.