Worktop replacement in Cricklewood

Yes. Cricklewood is on the patch, and the postcodes we work here are NW2. It is worked on our north west London run, along with the rest of Brent. Where the frontage is a clearway the unload happens away from the door and the carry gets longer, which is a crew and time question rather than a stone one. We stage the strip-out so the old tops leave in one trip rather than trickling out across the afternoon. The waste run is planned, not improvised. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

These kitchens are full of boxed soil stacks, gas risers and heating pipework, and the boxing usually stops short of the ceiling. The lift car is usually too short and too low to take a full-length piece flat or on edge, so stone either goes up the communal stairs with their half-landings and winders, or the run is designed with joins that suit the staircase rather than the kitchen. Sound carcasses are the one condition. First-floor maisonette kitchens are the recurring headache: the piece has to go up a domestic staircase with a half turn, so plan the joint before quoting a single length.

The Broadway is an A road with loading restrictions and bus lanes, so vans park in side streets and the crew carries. Mansion blocks vary wildly, some with a small original lift too shallow for a full slab and a stone staircase as the only alternative. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. That is agreed before a plumber is booked.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop templating and worktop splashbacks & upstands. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. Old tops out in the morning, new stone down and sealed the same afternoon. A day, not a project. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. Going from a 38mm laminate to 20mm or 30mm stone drops the surface, which shows against tiles, a window board and any freestanding appliance. Carcasses have to be sound first. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A boxed soil stack or service riser in the corner of a run eats into the worktop depth and has to be scribed around rather than cut square. We would rather find it at template than on the morning, which is why the templater looks behind the units. It is the usual surprise, and it is a known one. Get the managing agent's or freeholder's approval and the permitted hours confirmed beforehand, and agree with the porter who protects the communal carpet, stonework and lift. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. A plumber disconnects before we arrive and reconnects after we leave, and that is worth booking early. Units kept, surface changed.