Worktop replacement in Childs Hill

Yes. Childs Hill is on the patch, and the postcodes we work here are NW2, NW11. It is worked on our north London run, along with the rest of Barnet. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. The waste run is planned, not improvised. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Cornice, picture rails and deep skirting survive in converted rooms, so the run stands off the wall and the back edge follows the units rather than the plaster. In most Victorian terraces the kitchen sits in the back addition, so you get a narrow galley with one outside wall and nothing square to work off. Units kept, surface changed, one day. Steep streets plus stepped front paths make the approach the hardest part, and a slab that fits the kitchen may still not turn at the top of a Victorian staircase.

The ground falls steeply towards the Finchley Road and Cricklewood, so streets are on a gradient with stepped front entrances and no driveways, and permit parking is enforced. Converted flats mean a stair carry on most jobs. Weight tells on a staircase more than anywhere else, because there is nowhere to set a piece down mid-flight and no way to change your grip once it is moving. With no room to turn, the old top gets cut up in the kitchen instead, which is dusty work and needs the room emptied first. The strip-out is planned around it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop templating and worktop splashbacks & upstands. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. The carcasses have to be sound, because stone is several times the weight of what is coming off. A day, not a project. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. Old tops out in the morning, new stone down and sealed the same afternoon. A day, not a project.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. Old laminate has often been holding a run square for years, and taking it off shows what the units were really doing. Carcasses have to be sound first. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Anything that has to stay accessible, a stopcock, a gas meter, a riser panel, is marked on the template so the stone is cut around it instead of over it. The old top has been hiding it, so the first honest look at it happens when the laminate comes off. The laminate has been covering it up. Have a plumber booked to disconnect the sink, tap and waste first thing and reconnect after we have gone, and clear the hallway and stairs completely so we can carry slabs through the house. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. If the carcasses are tired the honest answer is that stone will find that out, and it is better said before than after. Units kept, surface changed.