Worktop templating in Fortune Green

Yes. Fortune Green is on the patch, and the postcodes we work here are NW6, NW2. It is worked on our central and north London run, along with the rest of Camden. Enforcement zones rarely accept a trade van unloading stone as an exemption, so this gets sorted before the date is confirmed rather than argued about afterwards. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Infill plots usually put the kitchen at the back with wide doors to a small garden, and that opening is the best route in. The template records that corner as it is, so the mitre closes tight instead of being cut to a theoretical 90 degrees. Recorded as it is, not as it was drawn. Edwardian rear walls here are usually rendered and bowed, so expect to scribe the back edge and pack the units before setting anything down.

Quiet residential streets with permit parking and better van access than most of NW6, though the climb up from Fortune Green Road is a real factor on the carry. Front doors open into a porch and then a hall with a right turn at the stairs, which is the pinch point on almost every house. A narrow entrance hall with a turn into the back of the house caps the longest piece we can physically get in, whatever the run itself measures. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. It goes on the drawing with the run dimensions.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop replacement. Developer-fitted kitchens come with thin cam-lock carcasses, which are fine under laminate and want bracing before stone goes on them. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn. Housings and integrated appliances are set out for a 38mm laminate top, so dropping to 20mm or 30mm stone changes the clearances and needs checking before anything is cut. The template visit is booked once the units are genuinely in, not when they are nearly in. Units fitted, fixed and level first.

Two runs meeting at an internal corner is the most common shape we fit, and the corner is where the decisions are. The template records every angle in that shape as it actually is rather than as the plan drew it. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Walls that bow along their length are the normal condition rather than the exception, and a straight-cut back edge will show a shadow gap at one end and touch at the other. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Plotted, not estimated. Boards taped or skimmed and finished, units fixed back to the wall and levelled off, and the appliances on site - the wall must be at its final thickness on template day, so no tiler or splashback fitter gets ahead of the worktop. Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. A template booked hopefully around another trade is the commonest cause of a wasted visit. Fitted, fixed and level, then we come.