Worktop design and quotation in Fulwell

Yes. Fulwell is on the patch, and the postcodes we work here are TW2, TW11. It is worked on our south west London run, along with the rest of Richmond upon Thames. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. It sits in the fitting line as time on site rather than as anything to do with the stone. Nothing here is added after the fact. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The chimney breast in the corner has usually been left in place, so the run gains a return and two scribed ends. Walls between the original room and the extension are frequently out of square, which affects the template but not the price; what does affect it is the appliance list, because a drop-in range, an undermount bowl and a half, a boiling tap and a separate drainer are four separately priced cut-outs. You see it before you commit to anything. Extension floors here are usually a new slab butted to the old suspended floor, so expect a step and set the kitchen level off the units.

Quiet, wide roads with driveways and garages, easy van access and space to open the tailgate on the plot; the level crossing at the station is the only regular hold-up. A short hard approach with no steps means a full-length piece can be walked in flat by two people rather than turned up on edge. That is why the fitting line on a quote reflects manpower and time rather than square metres. You see that figure before we template, not after.

It is one of the three we do most here, behind worktop installation. Same template visit, same workshop, same installers either way. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Itemised, so it can be compared honestly. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Material is the slab only, and it says so.

Because a peninsula is seen from both sides, the underside of any overhang gets the same edge treatment as the top, which is easy to leave out of a spec. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. Shape first, area second. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Level has to hold across the whole room rather than along one wall, or a floor that falls end to end shows as a step where two pieces meet. It is fabrication time rather than material, so it appears on the fabrication line and not in the square metre figure. Better on the quote than in a variation. Send the extension drawing or the unit layout with the actual appliance model numbers, since cut-out sizes come from the appliance, not the cabinet. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. Nothing is payable until we template, so a quote can sit while consents and decisions catch up. Nothing payable until template.