Worktop fabrication in Fulwell

Yes. Fulwell is on the patch, and the postcodes we work here are TW2, TW11. It is worked on our south west London run, along with the rest of Richmond upon Thames. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A side alley and a back door mean most pieces go in whole, and it is the alley width rather than the front door that decides it. What does drive the bench work is the knocked-through kitchen-diner: the return worktop and any peninsula are seen end-on from the dining side, so we nest the pieces so the veining carries across the internal corner in the same direction rather than turning through ninety degrees. Settled on the drawing, cut once. Extension floors here are usually a new slab butted to the old suspended floor, so expect a step and set the kitchen level off the units.

Quiet, wide roads with driveways and garages, easy van access and space to open the tailgate on the plot; the level crossing at the station is the only regular hold-up. Where the van stands level with the front of the house a piece gets handled twice instead of five times, and stone breaks on handling rather than on the road. The maximum piece length is fixed at drawing stage and every join is placed over a cabinet gable from there. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop installation, worktop design & quotation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Nested for the job in front of us. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match.

The free end is what needs deciding early: square edge, mitred apron down the end, or a full waterfall to the floor, and a waterfall is cut in sequence off the same part of the slab. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Floors settle, and once base units are packed and levelled properly the stone sits true while everything else in the room admits it is not. Internal corners are machined with a radius and polished, and kept well clear of any join or cut-out. The drawing decides it, not the fitter. The peninsula end detail needs deciding up front - square edge, mitred apron down the end, or a full waterfall - because a waterfall end has to be cut in sequence off the same part of the slab as the top. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. Dry-assembled before it leaves.