Worktop fabrication in Heathfield

Yes. Heathfield is on the patch, and the postcodes we work here are TW2. It is worked on our south west London run, along with the rest of Richmond upon Thames. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. That is the last thing settled before dispatch. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The back door frequently opens straight into the kitchen, which is the best carry route in the house and the one people forget to mention. Where a full length can come down the side and in at the back, the nest follows the slab instead of the building. Every join over a gable, clear of every cut-out. These kitchens have a back door mid-run, so the top ends at a doorway and the end grain has to be finished properly instead of hidden by a unit.

Bounded by the A316 and the Duke of Northumberland's River, so approach roads are limited and the estate layout is loops and cul-de-sacs; parking is on-street or on short driveways with a turning head that fits a van. Even an easy kerbside carry wants the pavement clear at the tail lift, because a three-metre piece on edge has a swing radius nobody expects until it is swinging. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. Once the cut-outs are machined there is no going back on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Nested for the job in front of us. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Pieces are dry-assembled and checked on the bench before anything is loaded. Same slab run, or it is not a match.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. Pieces are dry-assembled on the bench before dispatch so the corners are known to close before they leave the workshop. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A chimney breast left in place splits a wall into two alcoves, and the two are rarely the same width and rarely parallel to each other. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The peninsula end detail needs deciding up front - square edge, mitred apron down the end, or a full waterfall - because a waterfall end has to be cut in sequence off the same part of the slab as the top. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. Changing an appliance after the nest is set means recutting the piece, not adjusting it. Dry-assembled before it leaves.