Worktop fabrication in Strawberry Hill

Yes. Strawberry Hill is on the patch, and the postcodes we work here are TW1, TW2. It is worked on our south west London run, along with the rest of Richmond upon Thames. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. Pieces are loaded in reverse fitting order so the first thing off the van is the first thing that goes down. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Houses of this period came with generous garages and utility rooms, so a second short run of stone is often part of the same job. Where a full length can come down the side and in at the back, the nest follows the slab instead of the building. Settled on the drawing, cut once. Big interwar houses have solid floors that fall towards the old back door, so worktop level and floor level diverge across a 4m run - shim early.

Quiet leafy roads with in-and-out drives and space to park on the plot, but a couple of railway-side roads narrow to single file and the level crossing holds traffic; mature front trees limit where a lorry can stop. Where the van stands level with the front of the house a piece gets handled twice instead of five times, and stone breaks on handling rather than on the road. The maximum piece length is fixed at drawing stage and every join is placed over a cabinet gable from there. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop templating and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Households sharing a house tend to want two prep areas rather than one, which usually means an island as well as a perimeter run. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match. A second kitchen or a kitchenette in an annexe is a small job with the same fixed template, fabrication and fitting lines as a large one. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Nested for the job in front of us.

An island is a single visible piece with four finished edges and no wall to hide against, so it is the piece the whole kitchen is judged on. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. Every join sits over a gable. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The peninsula end detail needs deciding up front - square edge, mitred apron down the end, or a full waterfall - because a waterfall end has to be cut in sequence off the same part of the slab as the top. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. Dry-assembled before it leaves.