Worktop fabrication in St Margarets

Yes. St Margarets is on the patch, and the postcodes we work here are TW1. It is worked on our south west London run, along with the rest of Richmond upon Thames. A controlled parking zone means either a visitor permit sorted in advance or a suspended bay, and a suspension is applied for days ahead rather than on the morning. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

These houses usually sit in their own grounds with a long approach, so the carry from van to door is longer than anything inside the building. Access is off a drive and through wide doors, so for once the piece size is not the constraint - the joins that go in are the ones we choose for layout and veining, not the ones the building forces. The bench proves it before the van moves. Gate piers and side alleys under a metre wide are the recurring problem - the slab often has to go through the house because it will not go round it.

A dense one-way street pattern with narrow carriageways, permit bays and a railway bridge that cuts the area in two; the estate roads are wider with driveways but several have gate piers set less than 2.5m apart. A side gate and a back door mean the stone never goes through the house at all, which keeps the dust and most of the risk outside. The maximum piece length is fixed at drawing stage and every join is placed over a cabinet gable from there. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop installation and worktop design & quotation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. So the nesting is planned around it rather than around a standard kitchen. Proven on the bench before dispatch. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Nested for the job in front of us.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

The returns into a breast recess are the tightest scribes in the room, and they are eased in rather than forced. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Machined to the real line. The range or Aga, the sink and the tap all need to be confirmed by model before nesting, because their clearances and hole positions set where the island can be cut. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. Sink and hob are dry-fitted on the bench before dispatch, whoever supplied them. The approved drawing is the instruction.