Worktop design and quotation in Golders Green

Yes. Golders Green is on the patch, and the postcodes we work here are NW11. It is worked on our north London run, along with the rest of Barnet. Enforcement zones rarely accept a trade van unloading stone as an exemption, so this gets sorted before the date is confirmed rather than argued about afterwards. Tell us at enquiry stage and it is priced properly, because a crew stood waiting is the most expensive thing on any job. It is one line among the others, and it is honest. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

These kitchens are full of boxed soil stacks, gas risers and heating pipework, and the boxing usually stops short of the ceiling. The lift car is the single biggest price driver here. That is what the itemised lines are for. Kosher layouts must be agreed before templating because the meat and dairy split changes sink positions, drainer grooves and joint locations across the whole kitchen.

Mansion blocks with small original lifts, stone stairs and porters, plus permit parking that is full by mid-morning along the main roads. Houses off the side streets have driveways, but the mansion flats are the defining access problem. The lift has to be booked and blanketed before anything moves, and that booking needs to cover the old tops coming out as well as the new stone going in. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. It appears as its own line rather than buried in a rate.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop fabrication. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Itemised, so it can be compared honestly. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Nothing payable until we template.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. The join count is stated with its reason. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Boxing is rarely the same depth at worktop height as it is at floor level, so measuring it low down is the usual reason a top will not sit back. Send photographs of every corner of the room and it gets priced properly first time. Priced as fabrication, not as area. Measure the internal lift car, width, depth and height, and photograph the stair turn and landing doors, then send those with the run lengths. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. Material is quoted as a supply range and the labour lines separately, because an installed rate per square metre is not a real number. Nothing payable until template.