Worktop installation in Hampton Hill

Yes. Hampton Hill is on the patch, and the postcodes we work here are TW12. It is worked on our south west London run, along with the rest of Richmond upon Thames. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. A van that has to move mid-fit costs the best part of an hour and takes a man off the tools to do it. The day is built around that window. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A flat over a shop is reached by a separate street door and a straight steep stair, and that stair is the whole access question. The fitting itself is about squaring up to walls that look modern and are not: block or breeze walls with a skim that has been patched over decades, so we still dry-lay and scribe rather than trust the template edge. Walked, measured, protected, then lifted. Flats above the shops have a stair with a tight top landing, so anything over 2.4m has to be jointed - measure the landing, not just the stair width.

High Street loading is timed and the parade is busy, so flats above shops mean a street door, a straight steep stair and a right-angle turn at the top; the residential roads behind have driveways and are far easier. Stone goes up on edge, and it is the half-landing turn rather than the flight itself that sets the maximum piece. We walk the route with a tape and protect it end to end before the first piece is lifted. That is what the morning is planned around.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. One visit, with the sink and hob seated and sealed before we leave. One visit, done properly. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. The fitting day is scheduled to suit that rather than to suit the diary. Sealed before we leave.

Two runs meeting at an internal corner is the most common shape we fit, and the corner is where the decisions are. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Walls that bow along their length are the normal condition rather than the exception, and a straight-cut back edge will show a shadow gap at one end and touch at the other. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Eased in, never forced. Unlock any rear or shared path gate and clear both the hall and the back approach so we can choose the better route on the day. Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. A half-day of access is not a fitting day, and it is better to say so at booking than to find out at eleven. Protection goes down first.