Worktop fabrication in Hanwell

Yes. Hanwell is on the patch, and the postcodes we work here are W7. It is worked on our west London run, along with the rest of Ealing. Without a bay the van ends up on a single yellow with a crew member watching it, which takes a pair of hands off the carry. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A long piece has to come through the front door, down the hall, round the newel post and through a doorway with a step down into the addition. The other constraint is the hall: a piece has to come through the front door, round the newel at the foot of the stairs and through a doorway into the back kitchen, so we size the pieces to the tightest turn on that route before we nest anything, which sometimes means splitting a run that would otherwise have gone in whole. Every join over a gable, clear of every cut-out. A lot of these terraces still have the original outside WC standing in the rear return, so the top has to stop and restart around it rather than run through.

The Uxbridge Road and the approaches to the viaduct congest badly, terraces have no driveways, and the streets near the station are permit-controlled. A narrow entrance hall with a turn into the back of the house caps the longest piece we can physically get in, whatever the run itself measures. The maximum piece length is fixed at drawing stage and every join is placed over a cabinet gable from there. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Same slab run, or it is not a match. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Pieces are dry-assembled and checked on the bench before anything is loaded. Nested for the job in front of us.

A galley run down a side-return extension usually measures longer than a slab will give in one length, so a join is designed in from the start rather than discovered. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A run can measure dead right at both ends and still belly out in the middle, which only appears once the template plots the intermediate points. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. Dry-assembled before it leaves.