Worktop fabrication in Harrow Road

Yes. Harrow Road is on the patch, and the postcodes we work here are W9, W10. It is worked on our central London run, along with the rest of Westminster. The realistic answer on a main road is an early slot, a spotter on the van and pieces staged in one movement rather than several trips. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Deck access means a long open walkway from the lift or the stair to the front door, and that walk happens with the piece on edge in whatever weather there is. The notch around a boxed stack is machined with a radius, because a square internal corner there is where a top fails. The bench proves it before the van moves. Batch refits mean repeated identical layouts, so it is worth templating two or three flats in one visit - just check each one, the concrete openings vary by 10-20mm between units.

Estates along the road use deck walkways, communal fob doors and lifts with a small car, and the road itself has bus lanes and few loading opportunities. Bin stores and bike racks routinely block the shortest route to the block entrance. Piece length is set by the internal diagonal of the lift car, not by the length of the slab. The maximum piece length is fixed at drawing stage and every join is placed over a cabinet gable from there. Once the cut-outs are machined there is no going back on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Batching several kitchens together is the one situation where buying a whole slab is cheaper per kitchen rather than more expensive. Pieces are dry-assembled and checked on the bench before anything is loaded. Nested for the job in front of us. A licensed shared house has fire-door and escape-route rules that decide how and when stone can be carried through the common parts. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Same slab run, or it is not a match.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Window boards and cills stand proud of the plaster, so the back edge of the top has to be plotted to where the units actually sit rather than to the wall. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. The drawing decides it, not the fitter. The stack boxing needs to be in its final form and the sink and hob on site before we machine, since a boxing that gets re-clad afterwards throws the notch out. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. Dry-assembled before it leaves.