Splashbacks and upstands in Harrow Road

Yes. Harrow Road is on the patch, and the postcodes we work here are W9, W10. It is worked on our central London run, along with the rest of Westminster. A red route means no stopping, and no stopping means exactly that, so the stone comes in from a side street or from a bay behind the property. Panels come off the van in one trip where possible, since a tall piece handled repeatedly is a piece asking to be chipped. Handling is where these pieces get damaged. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Deck access means a long open walkway from the lift or the stair to the front door, and that walk happens with the piece on edge in whatever weather there is. That suits a full-height piece, because a large flat panel bonded across its back is more stable on concrete than a run of small tiles ever was. The wall makes that decision, not the brochure. Batch refits mean repeated identical layouts, so it is worth templating two or three flats in one visit - just check each one, the concrete openings vary by 10-20mm between units.

Estates along the road use deck walkways, communal fob doors and lifts with a small car, and the road itself has bus lanes and few loading opportunities. Bin stores and bike racks routinely block the shortest route to the block entrance. Where the lift will not take the longest run we design a join in rather than gamble, because a piece that will not go up has to go back on the van. Splashback panels are lighter than a worktop and far more awkward, because a tall thin piece has to be carried on edge and cannot be tilted to clear a turn. Joint positions follow from that.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Small kitchens in a shared house are all short runs and tight cut-out spacing, which is more bench work per square metre than one large kitchen would be. Ordered later from a different batch, the match is not reliable exactly where the pieces meet. Sockets final before template. Batching several kitchens together is the one situation where buying a whole slab is cheaper per kitchen rather than more expensive. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Siliconed to the worktop, never grouted.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Long runs almost never take a single panel, so the joint positions want agreeing before anything is templated. The joint to the worktop is siliconed, never grouted. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A low sill over the sink run is what decides between an upstand and stone dying into a window board, and there is often less clearance than an upstand is tall. A tall panel that fits at the worktop will stand off the wall at the top unless the wall is dubbed out or the panel is scribed. An upstand rides what a panel exposes. Any surface trunking or conduit has to be rerouted or accepted and boxed before templating, because the stone cannot be scribed around a live conduit on site. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. Splashbacks are cut from the same slab run as the tops, so they have to be decided before fabrication, not after. The wall has to be ready.