Kitchen worktops in Ickenham

Yes. Substantial detached houses with large square kitchens built around a freestanding range cooker, big islands with 40mm or mitred 100mm edges, and a fair amount of full design-led remodelling rather than replacement. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. The load plan follows from it.

1930s Metroland detached, interwar semi, village conservation area cottage and Swakeleys estate house. Solid brick with a render coat is firm to work against and out of plumb, so the scribe at worktop height is different from the one at plinth level. These are typically two runs and a return, often into a rear extension, and the return piece is the awkward one, short, wide and rarely nesting well against the long pieces on the slab, so slab yield rather than total area is what pushes the material line up. Priced from the building, not from a rate card.

The village core around the pond is conservation-controlled and narrow, but the surrounding estates have wide drives with room to turn. Low bridges on the Metropolitan line approach catch out taller vehicles. Where the van stands level with the front of the house a piece gets handled twice instead of five times, and stone breaks on handling rather than on the road. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. It appears as its own line rather than buried in a rate.

Worktop design & quotation, worktop installation and worktop fabrication, in that order. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. So the nesting is planned around it rather than around a standard kitchen. Proven on the bench before dispatch. Range cookers dictate the aperture, so measure the appliance itself and hold a 3mm gap each side rather than trusting the manufacturer's spec sheet.

If the island is a few hundred millimetres longer than the usable length of a slab, a second slab gets bought to gain that overhang, and the whole slab is paid for rather than the part used. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. Walls that bow along their length are the normal condition rather than the exception, and a straight-cut back edge will show a shadow gap at one end and touch at the other. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Dry-lay, mark, cut, then bond. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. The approved drawing is the instruction. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.