Worktop design and quotation in Little Venice

Yes. Little Venice is on the patch, and the postcodes we work here are W9. It is worked on our central London run, along with the rest of Westminster. Enforcement zones rarely accept a trade van unloading stone as an exemption, so this gets sorted before the date is confirmed rather than argued about afterwards. Where a bay suspension or a permit is needed, that is a real cost and it goes on the quote instead of appearing later. It is one line among the others, and it is honest. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The stair to the lower ground floor has a turn at the bottom and a low soffit above it, and both are measured before anything is nested. If the island top is a few hundred millimetres longer than the usable length of a slab, you buy a second slab to gain that overhang, the whole slab, not the part you use, and that is a material decision worth more than any other line on the quote. Priced from the building, not from a rate card. Boat galleys need thin, light material and radiused edges cut to a hull curve - it is a template-and-fabricate job, nothing about it is standard kitchen dimensions.

Canal-side streets are narrow with permit bays and bridge weight and width limits at Warwick Avenue, and several buildings back onto the towpath with no vehicle access at all. Stucco villas have a raised front entrance with six or seven stone steps. A narrow entrance hall with a turn into the back of the house caps the longest piece we can physically get in, whatever the run itself measures. We price the carry from what you tell us about the route, so photographs of the approach are worth more to us than a floor plan. You see that figure before we template, not after.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop fabrication and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. Comparing quotes only works when they itemise the same things, and this is where the differences usually hide. Itemised, so it can be compared honestly. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Nothing payable until we template.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. Shape first, area second. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a breast interrupts a long wall the join can often go there, so it reads as a natural break rather than a line in the middle of a worktop. Send photographs of every corner of the room and it gets priced properly first time. Better on the quote than in a variation. Send the island size including the overhang and which side people sit at, the stool count, and confirm the edge profile you want and which edges are to receive it. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. The quote is written so it can be read by whoever is paying rather than only by whoever is standing in the kitchen. Written to be read by whoever is paying.