Worktop replacement in Little Venice

Yes. Little Venice is on the patch, and the postcodes we work here are W9. It is worked on our central London run, along with the rest of Westminster. Enforcement zones rarely accept a trade van unloading stone as an exemption, so this gets sorted before the date is confirmed rather than argued about afterwards. We stage the strip-out so the old tops leave in one trip rather than trickling out across the afternoon. The waste run is planned, not improvised. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Conservation and listing conditions are common, which affects what can be altered around the kitchen rather than what stone goes on the units. Any island overhang past about 300mm will not carry weight on the carcass alone, so flat steel bar or brackets have to be let into the units first, and that is agreed at template stage, not on fit day. What is under the old top is the real question. Boat galleys need thin, light material and radiused edges cut to a hull curve - it is a template-and-fabricate job, nothing about it is standard kitchen dimensions.

Canal-side streets are narrow with permit bays and bridge weight and width limits at Warwick Avenue, and several buildings back onto the towpath with no vehicle access at all. Stucco villas have a raised front entrance with six or seven stone steps. Door width, hall width and the diagonal at the turn are three separate measurements, and it is the diagonal that catches people out. With no room to turn, the old top gets cut up in the kitchen instead, which is dusty work and needs the room emptied first. It sets what the day actually looks like.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop fabrication and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. Old tops out in the morning, new stone down and sealed the same afternoon. A day, not a project.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Going from a 38mm laminate to 20mm or 30mm stone drops the surface, which shows against tiles, a window board and any freestanding appliance. The units stay, the surface changes. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

The returns into a breast recess are the tightest scribes in the room, and they are eased in rather than forced. The old top has been hiding it, so the first honest look at it happens when the laminate comes off. The laminate has been covering it up. Have a fitter or joiner fix and level the island units beforehand, and get the sink, taps, hob and any range on site before templating so we cut to the actual appliances. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. If the carcasses are tired the honest answer is that stone will find that out, and it is better said before than after. Units kept, surface changed.