Worktop templating in London Bridge

Yes. London Bridge is on the patch, and the postcodes we work here are SE1. It is worked on our south east London run, along with the rest of Southwark. A dedicated loading bay or service yard is the easiest arrangement in a managed building, provided the slot is booked and someone has the key to the shutter. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Poured screed over steel decking can fall away across a long run, so level is checked across the whole room before anything is packed. Exposed brick and steel is the whole job here: the brick face is not a flat plane, it moves in and out over its height and along its length, so the scribe is taken at the exact height the worktop will sit rather than off the wall generally. Recorded as it is, not as it was drawn. Book the loading window and template with the appliances in place, because there is no coming back for a second look here without another permit.

One of the worst areas in the borough for kerbside - a 24-hour bus and taxi environment, timed loading only, and buildings that insist on out-of-hours deliveries through a goods entrance away from the main lobby. The van gets close to the door and the stone comes off the tail lift onto a trolley, which is about the shortest carry we ever get. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop replacement. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Units fitted, fixed and level first. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Boxing is rarely the same depth at worktop height as it is at floor level, so measuring it low down is the usual reason a top will not sit back. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Measured at worktop height, nowhere else. Units fixed and levelled, all steelwork and brick cleaned, sealed and finished, and any boarded sections completed to final thickness so the template picks up the surface the stone will actually meet. Quartz is the sensible default in a rental: nothing to seal, nothing to maintain, and nothing an incoming tenant needs briefing on. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come.