Kitchen worktops in Lower Clapton

Yes. Georgian terraces around the square with small original rooms and listed constraints, plus long Victorian terraces mostly in flats where the kitchen sits in the back addition at about 3m. Whole-house work is growing and tends to mean a rear extension with a peninsula rather than a full return. Without a bay the van ends up on a single yellow with a crew member watching it, which takes a pair of hands off the carry. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. The templater needs a proper stop, not a pause.

Georgian terrace, Victorian terrace, post-war estate and conversion flat. The flat entrance door and the internal doorways are usually tighter than the communal stairs, which is the opposite of what most people assume. Victorian party walls and chimney-breast returns bow along their length, so the template plots the real line rather than assuming a straight one - the template picks up points every few hundred millimetres down the back of the run and the drawing carries that curve through to the saw. Recorded as it is, not as it was drawn.

Lower Clapton Road carries buses with restricted loading and the side streets are permit-only with filters. The Georgian houses have narrow original doors, steep stairs and a level change between the front and rear rooms. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions.

Worktop templating, worktop replacement and worktop installation, in that order. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. Where the window is fixed there is no second day to fall back on, so the prep list matters more than usual. One visit, done properly. In the Georgian houses the floor drops a step between front and rear, so set the units off a datum line rather than the floor or the finished top will read as sloping.

A peninsula is an island with one end tied to a run, which means the join between them has to be planned rather than allowed to happen. Old laminate has often been holding a run square for years, and taking it off shows what the units were really doing. The units stay, the surface changes. A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Measured at worktop height, nowhere else. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. The fitting day is arranged with whoever can actually give us access for the whole slot. Access for the whole slot, or a different day. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.