Splashbacks and upstands in Lower Clapton

Yes. Lower Clapton is on the patch, and the postcodes we work here are E5. It is worked on our east London run, along with the rest of Hackney. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. Panels come off the van in one trip where possible, since a tall piece handled repeatedly is a piece asking to be chipped. Handling is where these pieces get damaged. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The flat entrance door and the internal doorways are usually tighter than the communal stairs, which is the opposite of what most people assume. Lath-and-plaster on the party wall and the chimney breast returns almost never runs true, so a 100mm upstand bedded on silicone is the honest answer here, it rides the bow and hides the junction the worktop can never close on its own. The wall makes that decision, not the brochure. In the Georgian houses the floor drops a step between front and rear, so set the units off a datum line rather than the floor or the finished top will read as sloping.

Lower Clapton Road carries buses with restricted loading and the side streets are permit-only with filters. The Georgian houses have narrow original doors, steep stairs and a level change between the front and rear rooms. A walk-up with winders at every half-landing means the piece is rested and re-gripped on the way, so the crew size goes up before the piece size comes down. It is usually the full-height panels rather than the tops that will not make the turn, and that only shows up when they arrive. Joint positions follow from that.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop replacement and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Siliconed to the worktop, never grouted. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. Ordered later from a different batch, the match is not reliable exactly where the pieces meet. Same batch, same run, same day.

A peninsula is an island with one end tied to a run, which means the join between them has to be planned rather than allowed to happen. Long runs almost never take a single panel, so the joint positions want agreeing before anything is templated. Joint placement is a decision, not an accident. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Level has to hold across the whole room rather than along one wall, or a floor that falls end to end shows as a step where two pieces meet. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. An upstand rides what a panel exposes. The chimney breast recess must be replastered and fully dry, and the hob and extractor positions fixed, before anyone templates a full-height piece into it. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. A 100mm upstand is the low-maintenance answer, and full-height stone is the one that has to be committed to early. Decided before fabrication, not after.