Worktop design and quotation in Manor Park

Yes. Manor Park is on the patch, and the postcodes we work here are E12. It is worked on our east London run, along with the rest of Newham. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. It sits in the fitting line as time on site rather than as anything to do with the stone. Nothing here is added after the fact. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Cornice, picture rails and deep skirting survive in converted rooms, so the run stands off the wall and the back edge follows the units rather than the plaster. The quote separates the joins the run needs from the joins the route forces, because they are different decisions with the same price. That is what the itemised lines are for. In the converted flats the kitchen was never designed as one, so services run in surface trunking and the top needs notching rather than a clean scribe.

Terraced streets with permit bays and a lot of parked cars, plus a level crossing and rail bridges that restrict which end of some streets you can enter from. Converted upper flats have a shared hall, a straight stair and a landing that will not take a full-length piece around the corner. Stone goes up on edge, and it is the half-landing turn rather than the flight itself that sets the maximum piece. We price the carry from what you tell us about the route, so photographs of the approach are worth more to us than a floor plan. You see that figure before we template, not after.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop installation and worktop replacement. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Itemised, so it can be compared honestly. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Nothing payable until we template.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. The join count is stated with its reason. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. It is fabrication time rather than material, so it appears on the fabrication line and not in the square metre figure. Priced as fabrication, not as area. Send us the run lengths, plus photos taken walking from the pavement through the hall to the kitchen so we can see the door widths and the stair turn. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. Material is quoted as a supply range and the labour lines separately, because an installed rate per square metre is not a real number. Written to be read by whoever is paying.