Worktop installation in Manor Park

Yes. Manor Park is on the patch, and the postcodes we work here are E12. It is worked on our east London run, along with the rest of Newham. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. A van that has to move mid-fit costs the best part of an hour and takes a man off the tools to do it. It is why the arrival time is what it is. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Lease conditions and the other flats in the building decide when noisy work can happen, so the fitting day has a start and a finish that are not ours to set. We measure the front door, the hall width and the turn into the kitchen before anything comes off the van, because a 3m piece has to swing through that corner on edge and stone does not bend to help you. Walked, measured, protected, then lifted. In the converted flats the kitchen was never designed as one, so services run in surface trunking and the top needs notching rather than a clean scribe.

Terraced streets with permit bays and a lot of parked cars, plus a level crossing and rail bridges that restrict which end of some streets you can enter from. Converted upper flats have a shared hall, a straight stair and a landing that will not take a full-length piece around the corner. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. We walk the route with a tape and protect it end to end before the first piece is lifted. That is what the morning is planned around.

It is one of the three we do most here, behind worktop templating. Same template visit, same workshop, same installers either way. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Where the window is fixed there is no second day to fall back on, so the prep list matters more than usual. One visit, done properly. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. One visit, with the sink and hob seated and sealed before we leave. Sealed before we leave.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. A layout that has been packed and levelled run by run instead of to one datum shows as a step where two pieces meet. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. The back edge is eased in progressively rather than offered up once and forced. Dry-lay, mark, cut, then bond. Clear the full hall and stairs route of furniture, bikes, coats and stair-gates, and keep the front door propped and unobstructed for the carry. Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. A half-day of access is not a fitting day, and it is better to say so at booking than to find out at eleven. Access for the whole slot, or a different day.