Worktop templating in Manor Park

Yes. Manor Park is on the patch, and the postcodes we work here are E12. It is run from the Essex side, covering Essex & East London. Enforcement zones rarely accept a trade van unloading stone as an exemption, so this gets sorted before the date is confirmed rather than argued about afterwards. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Cornice, picture rails and deep skirting survive in converted rooms, so the run stands off the wall and the back edge follows the units rather than the plaster. Alcoves either side of the breast are rarely the same width and rarely parallel, so each one is templated as its own piece with its own scribe. Two to three hours, once the units are in. In the converted flats the kitchen was never designed as one, so services run in surface trunking and the top needs notching rather than a clean scribe.

Terraced streets with permit bays and a lot of parked cars, plus a level crossing and rail bridges that restrict which end of some streets you can enter from. Converted upper flats have a shared hall, a straight stair and a landing that will not take a full-length piece around the corner. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. It goes on the drawing with the run dimensions. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop replacement. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. The template visit is booked once the units are genuinely in, not when they are nearly in. Appliances on site, not on order. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. The template records every angle in that shape as it actually is rather than as the plan drew it. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A run can measure dead right at both ends and still belly out in the middle, which only appears once the laser plots the intermediate points. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Plotted, not estimated. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. No stone is cut from a plan.