Worktop templating in Morden

Yes. Morden is on the patch, and the postcodes we work here are SM4. It is worked on our south west London run, along with the rest of Merton. Where the van can pull up level with the gate the pieces are handled the fewest times, which is what actually protects them. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Rear access through a garden or a shared path means long pieces can usually come in whole from the back. Unit height is the other issue: legs sit on an uneven screed or hard concrete with no give, so the template reads the top of every carcass rather than assuming they share a height. Recorded as it is, not as it was drawn. These small kitchens leave no tolerance, an L that is 15mm long cannot be trimmed on site without moving a fixed appliance, so template both legs to the wall rather than off the cabinets.

Around the station and the shopping parade the traffic and bus stands make standing time short, but the residential estates behind are uncontrolled and easy to park in. Older blocks have narrow communal stairs with a tight quarter turn at each landing. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. It goes on the drawing with the run dimensions.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn.

Two runs meeting at an internal corner is the most common shape we fit, and the corner is where the decisions are. Join positions and vein direction are marked on the template drawing before it leaves site. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Boxing is rarely the same depth at worktop height as it is at floor level, so measuring it low down is the usual reason a top will not sit back. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Plotted, not estimated. Every base unit fixed to the wall, packed and levelled, and any dry-lining or patching completed - the template reads the wall face it is given, so that has to be the finished face. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. No stone is cut from a plan.