Worktop templating in Wimbledon Chase

Yes. Wimbledon Chase is on the patch, and the postcodes we work here are SW20, SW19. It is worked on our south west London run, along with the rest of Merton. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Where the roof has been converted there is usually a steel over the kitchen that went in after the walls, and the run beneath it is worth checking for square. The typical 1930s kitchen sits at the back with a low window over the sink run, so the template records the exact sill height above the units to settle whether an upstand fits or the stone has to die into a window board. No stone is ever cut from a plan. Bungalow ceilings are low, which means tall wall units come down close to the top, check hob clearance and upstand height before cutting the splashback panel.

Driveways and dropped kerbs are common so the van gets close to the door, and single-storey properties mean the carry is level from van to room. The constraint is usually a low porch canopy or a narrow front door reveal rather than stairs. A narrow entrance hall with a turn into the back of the house caps the longest piece we can physically get in, whatever the run itself measures. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. The template records it along with everything else.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop installation, worktop splashbacks & upstands and worktop replacement. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Two to three hours on site, with the sink, tap and hob physically present. Units fitted, fixed and level first.

Three runs means two internal corners, and each corner is a decision about mitre or butt joint before anything is nested. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a breast interrupts a long wall the join can often go there, so it reads as a natural break rather than a line in the middle of a worktop. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Plotted, not estimated. All base units in, including anything standing on the later extension slab, walls skimmed to final thickness, and the sink, tap and hob delivered so cut-outs and tap centres are set from the actual items. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. A template booked hopefully around another trade is the commonest cause of a wasted visit. No stone is cut from a plan.