Kitchen worktops in North Wembley

Yes. Classic interwar semi layout: a small square kitchen at the back with the larder alcove knocked out, and about half the stock has taken the side return or a modest rear extension to make one wider room. Where the extension has gone in you get a 3m to 3.6m run against the flank wall plus a short island or peninsula, and a separate utility only if the garage has been converted. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. The fitting slot is set around it, which is why we ask about it when the date is booked and not before we leave the yard. It is why the arrival time is what it is.

1930s semi, 1930s short terrace and 1950s infill. Houses of this period came with generous garages and utility rooms, so a second short run of stone is often part of the same job. The typical 1930s kitchen sits at the back with a low window over the sink run, so the template records the exact sill height above the units to settle whether an upstand fits or the stone has to die into a window board. Two to three hours, once the units are in.

Front driveways and dropped kerbs on most of the semis, so the van gets close and a slab can be walked up a short path. Side gates are typically 800mm to 900mm and the side alley is the fastest route into a rear extension if the fence panel can come out. The side passage is the measurement that matters, because a piece has to be carried flat down it and then turned in at the back door, and the turn is always tighter than the passage. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions.

Worktop installation, worktop templating and worktop design & quotation, in that order. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Nothing payable until we template. The flank wall in these extensions bows over 3m more often than people expect, so template after plastering and expect the back edge to need easing.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. One datum for the whole room. Floors settle, and once base units are packed and levelled properly the stone sits true while everything else in the room admits it is not. It is fabrication time rather than material, so it appears on the fabrication line and not in the square metre figure. Better on the quote than in a variation. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. The quote is written so it can be read by whoever is paying rather than only by whoever is standing in the kitchen. Written to be read by whoever is paying. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.