Kitchen worktops in Wembley Central

Yes. Mostly rear kitchens in narrow terraces and interwar semis, many opened into the old dining room so the run turns an L along two walls. Multi-generation households here cook heavily, so we get asked for a second hob or a separate wet-prep sink far more than for an island, and full-height splashbacks behind a wok burner are routine. Enforcement zones rarely accept a trade van unloading stone as an exemption, so this gets sorted before the date is confirmed rather than argued about afterwards. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause.

Victorian bay-fronted terrace, 1930s semi, 1960s low-rise flat and 2010s infill block. A small room puts the sink, hob and tap cut-outs close together on one short length, and the bridge of stone left between them decides whether it can be cut in one piece. In most Victorian terraces the kitchen sits in the back addition, so you get a narrow galley with one outside wall and nothing square to work off. Units kept, surface changed, one day.

Terraced streets off the High Road are permit-controlled with no driveway on the older stock, so a 3m slab usually comes off the van at the kerb and goes in through the front door and down the hall. Match-day and event traffic management around the stadium closes and diverts roads at short notice, so a morning slot is safer than an afternoon one. Carrying through the house means protecting the whole route first: floor boarded, banister padded, and the front door held open on a wedge rather than by hand. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. The strip-out is planned around it.

Worktop replacement, worktop templating and worktop splashbacks & upstands, in that order. Households sharing a house tend to want two prep areas rather than one, which usually means an island as well as a perimeter run. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project. Half these houses have had the kitchen moved at least once, so the walls behind the old units are rarely square and the templater should expect to scribe the back edge rather than trust the plaster.

Where the return runs into a wall that is out of square, the corner is templated as the angle it really is rather than as ninety degrees. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. Joint placement is a decision, not an accident. Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. The old top has been hiding it, so the first honest look at it happens when the laminate comes off. Found at template, not on fit day. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. A 100mm upstand is the low-maintenance answer, and full-height stone is the one that has to be committed to early. Decided before fabrication, not after. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.