Worktop installation in North Wembley

Yes. North Wembley is on the patch, and the postcodes we work here are HA0, HA9. It is worked on our north west London run, along with the rest of Brent. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. The fitting slot is set around it, which is why we ask about it when the date is booked and not before we leave the yard. The day is built around that window. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Solid brick with a render coat is firm to work against and out of plumb, so the scribe at worktop height is different from the one at plinth level. Access is usually the easy part here, as most of these have a side gate and a back door straight into the kitchen, so we carry down the side alley rather than through the house and keep the mess outside. The slow parts are slow for a reason. The flank wall in these extensions bows over 3m more often than people expect, so template after plastering and expect the back edge to need easing.

Front driveways and dropped kerbs on most of the semis, so the van gets close and a slab can be walked up a short path. Side gates are typically 800mm to 900mm and the side alley is the fastest route into a rear extension if the fence panel can come out. Garden routes carry their own hazards: a drain cover, a step up to a patio, wet decking, or a lawn that will not take a loaded trolley. The fitting day is planned backwards from that point, before anything comes off the van. That is what the morning is planned around.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop templating and worktop design & quotation. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. One visit, with the sink and hob seated and sealed before we leave. One visit, done properly. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. The fitting day is scheduled to suit that rather than to suit the diary. The prep list is not optional.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. Joins are pulled with suction clamps and finished flush, then colour-matched, which is the last thing done rather than the first. Nothing is bonded until the whole run sits flat. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Dry-lay, mark, cut, then bond. Unlock and clear the side gate and back door, and move bins, planters and washing lines out of the alley run. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. A half-day of access is not a fitting day, and it is better to say so at booking than to find out at eleven. Access for the whole slot, or a different day.